OT: Found cabinet maker in No. VA

[Geekstar]

Delete at will AB. Maybe I should move to Marketplace??

To me this is non-commercial, because I won't get a dime. Also very Altec related because you can't play
Altec drivers without cabs. I have several pairs of drivers sorely in need of wood.

I had a hard time finding a good cabinet maker. People offering other services and products are discussed here all the time, including cabinet sellers on ebay.

I thought over the propriety of the post and decided that it was a public service announcement. How many people on this board have loose drivers?

Of course, I will be writing up my 756B project in a thread here.

Here's a preview video MOV for folks with high speed: http://silbatoneacoustics.com/images/MVI_0261.MOV


BTW: The guy is member ID delwon here.

[analog addict]

Pix? How much did your project cost?

[bowtie427ss]

Pix? How much did your project cost?

Allan, it'd be a bit of a road trip for you(or him), and this may be a little "forward" of me, but Geekstar is a fella that you need to make in person contact with since you fellas are kinda in each others distant backyards. I think you'd also enjoy the articles he's written on 2A3's, and probably several others as well.

[Alien_Shore]

I'm 3 hours from Greensboro. Let's do an Altec BBQ!

[Altec Best]

Delete at will AB. Maybe I should move to Marketplace??

To me this is non-commercial, because I won't get a dime. Also very Altec related because you can't play
Altec drivers without cabs. I have several pairs of drivers sorely in need of wood.

I had a hard time finding a good cabinet maker. People offering other services and products are discussed here all the time, including cabinet sellers on ebay.

I thought over the propriety of the post and decided that it was a public service announcement. How many people on this board have loose drivers?

Of course, I will be writing up my 756B project in a thread here.

Here's a preview video MOV for folks with high speed: http://silbatoneacoustics.com/images/MVI_0261.MOV


BTW: The guy is member ID delwon here.

Thanks Joe ! And Thank You for the kind PM !!!! I know that you aren't profiting from these cabs.. But it is a business of making cabs from scratch for a profit (Business).. Something we don't allow here or on any forum for that matter... If we allow one do you see how this could quickly snowball into a Classified section ?

And your also correct that a more appropriate forum would be the Marketplace.. However as was explained to me.Todd only wants original Altec manufactured products (Cabinets,drivers,networks) there or Altec related (WE,etc.). No exceptions !

I think a more appropriate way to mention this cabinet maker is to go ahead and start your 756B thread and mention the cabinet maker in that thread.. Like how you went about selecting a specific cabinet,and or a cabinet maker...

I'm sending an email feel free to contact me anytime !

I'm going to close this thread.I'll run it past Todd, about moving your original post to the Marketplace..


Kind Regards !